Egro ONE - Product Setup

Technical Manual V6.00 34 01.05.2017
Product setup
Coffee
Boiler temperature
Temperature set point of the coffee boiler
Group heater
Power management of the group heater
Auto-Rinse time
Time for the automatic rinse after the last brewed coffee 0=OFF
First Coffee
Increases the amount of coffee powder for the first coffee after 3 min of no coffee
Delivery time
Shows the brewing time after the preparation
Grinders
Grind left time/10g
Time to grind 10g of coffee with the left grinder
Grind right time/10g
Time to grind 10g of coffee with the right grinder
Grind left test
Test function to grind and adjust the correct amount of ground coffee for the left grinder
Grind right test
Test function to grind and adjust the correct amount of ground coffee with the right grinder
Left time %
Time of the left grinder – 50% = both grinders ground the same amount
SAG
Module Type
Modes: Off – Manual – Self-regulating – End switch
Ref. Product left
Defines the reference product for the left grinder, most time «Espresso»
Target time left
Requested target time for the left reference product
Ref. Product right
Defines the reference product for the right grinder, most time «Espresso»
Target time right
Requested target time for the right reference product
Man. Setting
Left grinder
If the parameter «SAG» «Module Type» is on manual, the grinder can be
adjusted with this menu.
Right grinder
Milk
Module type
Type of the milk module – not installed / Coolbox /Fridge
Auto-Rinse time
Time for the automatic rinse after the last delivered milk
Pump purge
Purge the milk pump circuit with the fridge 0=OFF
Milk rinsing
Renew hourly the milk in the milk tubes when having a cool box
Correction time
Delay of steam for the milk delivery after a milk auto-rinse
Rinsing time
Increase of the rinsing time in case of longer tubes (under counter installation)
Blowout time
Increase of the blowout time in case of longer tubes (under counter installation)
Milk temperature
Configuring and testing three different milk temperature (Fast speed – low temperature, low speed
– high temperature)
Foam texture
Configuring three different levels of foam texture
Left sensor / Single
Sensor type
Off=no sensor; Switch = capacitive sensor; Level = pressure sensor
Capacity (l)
Capacity of the milk container
Calibration
Autocalibration
Starts the automatic calibration and sets the values for the
milk level measurement
Zero level (cm)
Value is from the sensor down to the minimum level; will
be set in auto calibration – should not be changed
High factor
Factors for the control of the milk pump speed. These
values will be set by the auto calibration and should not be
changed
Medium factor
Low factor
Residual Milk
“Off” blocks all milk product, when milk level is too low;
“ON” blocks only the milk products, which cannot be done anymore
Warning level (cm)
Level of milk in the container, to activate the Low level-information; with 0.0
the function is deactivated
Right Sensor
The right sensor has the same submenu as the left sensor. It will not be repeated.
iSteam
iSteam module
iSteam installation
Foamed milk
Shut-off temp.
Shut-off temperature of the foamed milk
Emulsion level
Emulsion level of the foamed milk
Steamed milk
Shut-off temp.
Shut-off temperature of the steamed milk
Emulsion level
Emulsion level of the steamed milk
Auto purge
Activates the indication to purge the iSteam after use
Auto purge time
Time after the last iSteam use before «Purge iSteam» is displayed
Powder
Module type
Installation of Powder module