Egro ONE - Machine Setup

Technical Manual V6.00 36 01.05.2017
Machine setup
Function mode
Stand-by mode
Sets coffee machine in stand-by
Payment mode
Sets coffee machine in payment system/register mode
Self-service mode
Sets coffee machine in self-service mode
General
Language
Select the display language
Buzzer
Activate buzzer
Change manager password
Set a new manager password using 4 digits
Change technician password
Set a new technician password using 4 digits
Illumination
Activates machine light
*Keyboard
Sets the number of product on a keypad machine
Coffee powder alert
Activates the coffee powder alert by software sensor
Grounds value
Amount of grounded coffee before «DRAWER FULL» is displayed
Trolley unit
Trolley installation
Unit converter
Temperature
Selects the temperature unit
Pressure
Selects the pressure unit
Preselection
Standard mode
Number of preselected beverages in Standard mode
Payment mode
No. of preselected beverages in payment mode
Boiler settings
Steam boiler
Steam boiler installed
Boiler steam pressure
Pressure set point of the steam boiler
Reduced power
Power for the boilers; OFF: 2 boilers can work together; ON: only one boiler
can work at the specific moment
Coffee boiler type
Defines the type of coffee boiler (3 or 2.5 kW)
Factory settings
Brewing chamber
Definition of the brewing unit with 15 or 18 grams
Lower Offset
These parameters are set with the «Auto calibration» of the brewing unit. They
should not be changed.
Using the brewing unit L61 (15 gr) they should be “0”
Upper Offset
P1 out
Position of the upper piston (in number of turns) to eject the coffee cake
P1 turns
Position of the upper brewing piston to brew coffee
P2 turns
Position of the lower brewing piston to eject the coffee cake
Autocalibration
Activates the automatic calibration and sets the values for the pistons
Hot Rinsing
Activates hot water valve for rinsing: 0 = no hot rinsing
100 = pulsed hot rinsing.
Old milk system: activates rinsing with cold water and parallel steam
Sensor Offset AS
Distance between the end switch and the photo sensor at the upper end of the
AS - Do not change!
Password: 2408
All grey fields are protected with an additional password
Data interface
Payment system type
Select the type of payment system
Decimal point
Number of decimal points
Coin value
Coin value #1…6
Value of each channel of the coin-checker
Smart card number
ID number of the smart card to uniquely associate a smart card to a coffee
machine
Remote control
Remote Control
Activate the connection for a tablet
Interface
Defines the connection of the tablet (BYO-fix or BYO-flex)
Telemetry
Telemetry
Activates the telemetry
Serial number
Displays the serial number to be used in the telemetry
Maintenance function
Initialization
Function to enable the first startup
Heaters
Switch off the heating elements of both boilers
Cool down
Cool down of the boilers