Egro ONE - 7 Egro BYO; Tablet Communication

Technical Manual V6.00 48 01.05.2017
7. Egro BYO
7.1. Tablet communication:
Activate the tablet in the menu «Machine setup», «Remote Control» «Remote Control».
Interface:
 BYO fix is used for the build in tablet. -> the tablet has to be set to «USB-Mode»
 “Do not check if tablet is charging” has not to be selected in the App-> otherwise the tablet does
not switch off, when the machine switch off.
 BYO flex (BLE) is used for an external tablet. -> the tablet has to be set on Bluetooth mode.
 “Do not check if tablet is charging” has to be selected in the App. -> General setting, when the
tablet is in the Bluetooth mode and is not charged from the coffee machine.
 CCI/CSI is used by communication via the serial interface -> set the tablet to «USB-Mode»
 “Do not check if tablet is charging” has to be selected in the App.
Note:
When changing the communication from the serial communication to Bluetooth, this must be changed in the
machine settings of the coffee machine and in the settings of the tablet.
Furthermore, the jumper on the extension board must be adopted, as shown below:
Jumper positon on extension board
left: Bluetooth Mode right: Serial connection (USB Mode)