Egro ONE - Basic Adjustments

Technical Manual V6.00 59 01.05.2017
8.4. Egro ONE Touch -> Egro ONE Multi Drink
For the conversion of an Egro ONE to a Multi Drink machine, the requirements as written in the beginning of chapter 7
must be fulfilled.
 Check software version – it has to be THIS release: SW_C5-01_T5-00_M5-00
 If the SW-version is different, bring the machine to the version (Version available in the technical download area)
 Migrate the machine from Egro ONE Touch to Egro ONE Multi Drink (Upgrade via USB-pen and the Load&Show
menu)
 At the end, do not restart the machine (just remove the USB-pen) and wait until the rinsing is finished.
 Switch off the machine
 Open front door, loosen the four screws of the touch screen and take it out
 Change the SD-card (see below)
 Place the touch screen in its frame, tighten the screws, close the front door
 Switch on the machine
 Now you have an Egro ONE Multi Drink
 Perform an initialization via Machine Setup/Maintenance function/Initialization
 Load the <Factory settings>
 Configure the machine at customer request
8.5. Egro ONE Multi Drink -> Egro ONE Touch
The conversion from a Multi Drink machine to an Egro ONE Touch with the standard interface need no special
requirement. Follow the sequence below with care!
 Switch off the machine
 Open front door, loosen the four screws of the touch screen and take it out
 Change the SD-card (see below)
 Open the left side of the housing
 Plug in USB adapter and keypad to control board.
 Switch on the machine
 Load SW and message file to control board
 Set jumper W4 to “Reset”
 Load SW and message file to the touch screen – Attention use package without control board software!
 Switch off the machine and remove the jumper
 Close the housing
 Switch on the machine
 Upgrade to the current SW-version