Egro ONE - Product Configuration

Technical Manual V6.00 37 01.05.2017
Machine setup
Serial number
Serial number of the machine
Insert the serial number
Insert the serial number of the machine
AS setting
Module Type
Activation of the automatic spout (AS)
Crash behavior
„Continue“- the spout tries if it can move on even there is a resistance
„Stop“- the spout does not move on
Upper sensor height
Height of the sensor from the cup grid – currently not in use
Cup distance
Value will only be set when AS with sensor.
Cup height 1…5
5 heights for different cup sizes
Software version
**Touch Bootloader
Shows the version of the touch boot loader
**Touch operating system
Shows the version of the touch operating system
**Touch SW
Shows the software version of the touch
**Touch message
Shows software version of the touch messages
**Touch parameters
Shows the software version of the touch parameters
Control board boot
Shows the software version of the control board boot
Control board SW
Shows the software version of the control board
HW Control board
Shows the hardware version of the control board
Control board USB SW
Shows the software version of the control board USB
Protocol version
Shows the protocol version
Control board messages
Shows the messages version of the control board
Control board parameters
Shows the parameters version of the control board
Powder Module
Shows the version of the Powder module control board
Version HW
Shows the hardware version
* Only for model Keypad
** Only for model Touch