Eizo FlexScan S1932 - Page 13

11
Chapter 2 Settings and Adjustments
3
Perform the AutoSize adjustment again with the analog screen
adjustment pattern displayed.
●  Toadjustickering,screenposition,andscreensize
automatically [AutoSize]
(1) Display Pattern 1 in full screen on the monitor using the “Screen
AdjustmentUtility”orthescreenadjustmentpatternles.
(2) Press .
The adjustment menu appears.
(3) Select (Analog).
(4) Select (AutoSize).
Flickering, screen position, and screen size are adjusted automatically.
(5) Afterconrmingthescreenmessage,select (OK).
If you select (Undo), the monitor returns to the pre-adjusted status.
If the screen is not displayed correctly even after adjusting in step
3 above, perform the adjustments according to the procedures on
the following pages. When the screen is displayed correctly, go to
step 5 “To adjust color gradation automatically [AutoRange]”.
4
Perform advanced adjustments by using (Manual) in the
adjustment menu.
Select
(Manual) to adjust the clock, phase and position, in this order.
● To eliminate vertical bars [Clock]
(1) Adjust the clock with
or of (Clock) to eliminate
vertical bars.
● Toremoveickeringorblurring[Phase]
(1) Adjust the phase with
or of (Phase) to remove
ickeringorblurring.
NOTE
• Press the control button slowly so as
not to miss the adjustment point.
• Whenblurring,ickeringorbars
appear on the screen after adjustment,
proceed to [Phase] to remove
ickeringorblurring.
NOTE
• Press the control button slowly so as
not to miss the adjustment point.
• Whenblurring,ickeringorbars
appear on the screen after adjustment,
proceed to [Phase] to remove
ickeringorblurring.
Attention
• Flickering or blurring may not be
eliminated depending on your PC or
graphics board.
Attention
• Flickering or blurring may not be
eliminated depending on your PC or
graphics board.