Eizo FlexScan S1932 - Setting Auto-Selection of the Input Signal [Input Signal]

23
Chapter 3 Connecting Cables
●
Setting auto-selection of the input signal [Input Signal]
Enable:WheneitherPCisturnedofforentersthepower-savingmode,the
monitor automatically displays signals of another PC.
Disable : The monitor does not detect the PC’s signals automatically. Switch an
input signal with .
(1) Press .
The adjustment menu appears.
(2) Select (Tool).
(3) The Enable/Disable setting is toggled by selecting (Input Signal).
Enable
Disable
(4) Select .
The mode selected is set.
NOTE
• When“Enable”isselectedfor[Input
Signal], the monitor’s power-saving
function works only when the two
PCs are in the power-saving mode.