Setting Up
User Manual Hemo Control
For initial start-up connect the device to the mains. The device should
remain connected to the mains until the integrated rechargeable battery
has been fully charged.
! Warning !
The mains adaptor is designed for a mains voltage of
100 - 240 V and a frequency of 50 – 60 Hz. For further
information refer to Section 10.1, Technical Data, on page 31.
For further enquiries contact your technical consultant or
distributor.
Figure 2 - Connection of mains adaptor
3.2.2 Switching the device on and off
The device is not provided with a separate switch. If the device is not
used for a longer period, it automatically switches to the energy-saving
Stand By mode. This period can be selected in the device menu; refer
to Section 6.9.5 on page 21.
The device can be switched on as follows:
Touch the display
Open or close the cuvette holder
Connect the mains adaptor to or disconnect it from the mains
To Next Page
Loading...