Device Menu
User Manual Hemo Control
6. Device Menu
In the Open state the Menu button can be used for opening the menu of
the device. Any alterations of settings need to be confirmed by pressing
OK. By pressing ESC the menu is left to the next higher menu level
without incorporating any alterations.
6.1 Information
-Measurements-
Total: Total number of measurements performed on
this device
Today: Number of measurements performed this day
Battery: Total number of measurements with battery
-Battery- Remaining capacity in %
-Memory- Pat: Number of new data / number of total data
-Serial number-
-Model number-
-Version- Software
Electronic hardware
Mechanical hardware
-DM- indicates if the DM function is activated.
The Hemo Control offers the option to enable later the data
management function by using a licence key offered by
EKF-diagnostic GmbH. In delivery state, the DM function is
not activated.
-Adaptation- Measured values can be adapted to other Hb measuring
methods. The measured values are converted by using the
entered equation and displayed.
Modifications can only be made by service staff. The
default setting is y=1.00x+0; no adaptation of the measured
value.
-SPN- ServiceProcessNumber; required by service staff only.
To Next Page
Loading...