20
If the measuring device fails to find a heart
rate monitor after a period of 10 seconds, an
error message will appear
16
.
Each time the Lactate Scout 4 is switched
on, the measuring device will attempt to
automatically connect to the registered
heart rate monitor. A brief acoustic warning
will be emitted if the existing connection
is temporarily interrupted. The measuring
device will then make three further attempts
to restore the connection. If the connection
fails due to the fact the heart rate monitor is
too far away, the measuring device will not
attempt to reconnect until the next time that it
is activated.
If you want to delete a registered heart rate
monitor, simply select the “Heart” symbol
again in the “Device settings” menu
2B
.
Confirm your selection by pressing the OK
button. To delete the heart rate monitor,
use one of the two arrow keys to select the
“Delete” symbol and confirm your selection by
pressing the OK button
17
.
16
3.1.5 Displaying information about
the device
If you choose the “Info” symbol in the “Device
settings” menu
2E
by using one of the two
arrow keys and confirm your selection by
pressing the OK button, you will be shown
the following information about the device,
firmware and device components. If you use
the arrow keys to browse through the pages in
this menu item, then the following information
will be displayed:
17
To Next Page
Loading...
Need help?
General
