29
4 Performing a step test
4.1 Step test mode
In addition to individual tests, the measuring
device can also be used to perform step
tests. In order to do so, all of the test results
recorded during a step test will be stored in
memory by the measuring device along with
the relevant configured parameters.
The general procedure for test preparation,
sampling and measurement is the same as the
individual test.
Insert the sensor into the measuring device.
You are then in measuring mode. Now use one
of the two arrow keys to select the respective
step test phase which the subject is in before
the measurement. You can choose between
the following step test phases:
- pre-load (for resting levels)
1
- load (for exertion values)
2
- after-load (for post-exertion values)
3
The black bar in the step test symbol indicates
the respective step test phase.
1
2
3
To Next Page
Loading...
Need help?
General
