30
You can begin with any of the step test
phases. However, you cannot change the
order of the test step phases. As an example,
pre-exertion cannot be selected after the
exertion phase.
The number of lactate values taken per step
test phase corresponds to the number of
measurements in that phase. The test results
are counted separately for each step test
phase. The number to the right of the step test
symbol indicates the number assigned to the
measurement/exertion level
4
-
6
.
Lactate levels are measured at each exertion
level during the “exertion” step test phase.
Themost recently selected step test phase
will always be used if you insert a new sensor.
The number of the next test is also displayed.
If you stay in step test mode, you can proceed
with this test or switch to later phases by
pressing the top arrow key. Alternatively you
can exit step test mode.
If you want to exit step test mode, hold down
an arrow key when the test result is displayed.
The “Exit” symbol for the step test will then
appear
7
.
4
5
6
7
To Next Page
Loading...
Need help?
General
