DmPackagingGroup
s.r.l
StradadelCascinotto156,
10156,Torino(TO)-Italy
Tel:011.99.10.455
e-mail:
info@dmpackagingroup.com
● "Target max": maximum value accepted as current target. Setting this parameter
and the next one to zero , will disable the controls.
● "Target Min": minimum value accepted as current target . By setting this parameter
and the previous one to zero, the controls are disabled.
● "Target": temperature value at which the module is managing the temperatures.
This setting corresponds to the one in “Work environment”
● "Modulation period": Time period, in milliseconds, used for modulation of the
heating module output . Adjustment of this parameter allows you to adjust the
frequency of ON / OFF transitions for heating output and thus the potential
duration of the mechanical parts connected to it.
On the right side of the screen it is possible to do the following:
● visualize the current temperature of the module and the current status of the
heating (red LED = active output - gray LED =output off)
● module activation ("PLAY" button)
● stop the module ( “STOP” button)
● viewing the current status of the calibration routine (Calibration: OK) or routine not
executed (Calibration: NO)
● Start calibration procedure ("PLAY Calibration" button). The procedure is performed
only after a password confirmation. And only if a pre-existing calibration is not
present.
● reset current calibration (button with double circular arrow). The reset is performed
only after a password confirmation. WARNING: Resetting the calibration, if
31
To Next Page
Loading...