19
6.1.1 To select measurement mode
Selection of measurement mode is now complete.
Note: Once the measurement mode has been selected, use LOC mode to prevent accidental modification
of the measurement mode. When your gauge is in LOC mode, all features (with the exception of the
calibration and units), are locked and cannot be altered by the user.
Press and hold the DOWN arrow key while switching on the gauge to toggle LOC mode on/off.
1. Press ON/OFF key to switch on the gauge.
2. Press UP arrow key to switch between the
measurement modes. The gauge will display
GAtE I-E, GAtE E-E, GAtE Auto or GAtE
PLAS depending on which mode the gauge is
in.
3. Repeat step 2 until correct mode is displayed.
1. Press ON/OFF key to switch on the gauge.
2. Press MODE key to activate features and
settings. The gauge will display GAtE I-E,
GAtE E-E, GAtE Auto or GAtE PLAS
depending on which mode the gauge is in.
3. Press SEND key to switch between the
measurement modes.
4. Press MODE key when correct mode is
displayed.
To Next Page
Loading...
Need help?
General
