29
If the memory location is currently full, the display will flash the FuLL symbol.
2. Press the CLR key to delete the contents of the memory location. The display will flash the memory
location (L011, L099, etc.) and the CLr symbol.
3. Take another measurement, and press the SEND key to write to the same memory location just
cleared.
8.4 DELETING CONTENTS OF AN ENTIRE BATCH
The user may require the contents of an entire batch to be cleared of all measurements. This would allow
the user to start a new list of measurements starting at memory location L001, for example. The procedure
is outlined in the following steps:
1. Press ON/OFF key to switch on the gauge.
2. Press MEM key to activate the data logging functions and settings.
3. Press SEND key to enter batch setup.
4. Press UP / DOWN arrow keys to scroll to the batch that is to be cleared of all measurements.
5. Press SEND key once again to select the batch. The display will flash FILE F-05 (or the batch
selected).
6. Press UP / DOWN arrow keys to scroll to the flashing CLr F-05 (or the batch selected).
7. Press SEND key to select the clear batch option. The display will show CLr?
8. Press CLR key to confirm and clear the contents of the entire batch.
9. Press MEM key at any time to exit data logging functions.
To Next Page
Loading...
Need help?
General
