Page 39 (40)
Rev 1 2018-03-21 www.elcon.se
Go to INDEX.
8 TRANSPORTATION/SCRAPPING/RECYCLING.
Before transportation remove all cables from the SA10A unit when moving/transportation the equipment.
Put the SA10A and the cables in intended locations in a transporting case (can be ordered from ELCON AB)
Scrapping/Recycling of replaced components shall be done according to local rules and laws.
Note: The SA10A contains a Lead-acid battery that must be take care off according to local rules and laws.
9 SA10A ACCESSORIES.
All accessories can be ordered directly from
Contact us and give us the below information depending on which spare part you are interested in.
Accessories kit including the following
1 x Accessories box
4 x black insulated clips
4 x red insulated clips
4 x black jumpers
3 x Test peg XRKA black
8 x Test peg XRKA red
2 x Fuses 3,15AT
Digital transducer RSI503 2500 pulses
Analogue transducer TLH150
Analogue transducer TLH225
Transporting case with wheels
Shunt 100µΩ ±0.5% for 200A Calibration.
RS232 Communication cable, SA10-PC (2.0m)
USB Mini to USB cable (1m)
Cable for digital transducer (10m).
Cable for analogue transducer (10m).
Current cables for resistance measurement
(10m)
Cable for Main Contacts (16m)
SA10A/BTS11 Basic training 2 days
SA10A/BTS11 Advanced training 1 day
For orders regarding different transducers as well as transducer cables,
please contact for the solution that fits your needs.
E-Mail: info@elcon.se
Phone: +46(0)240-641120
Fax: +46(0)240-641319
To Next Page
Loading...