CTC-1132 868AM 2007.07.18
10
Step 3. Press “ “ key, the next screen will
ask you to enter your new PIN code
and repeat it for double confirmation.
Step 4. Follow the same steps as described in
“Set your own pin code” to edit.
2. Temporary Code
z The Temporary Code is used to
arm/disarm the system for a temporary
user and is valid only once per Arming and
once per Disarming. Afterwards, the
Temporary Code is automatically erased
and needs to be reset for a new Temporary
user .
z The Temp. Code consists of 4 digits and is
not activated as default by the factory.
z To Set Temporary Code
Step 1. Use the arrow keys to select “Temp.
Code” and press “OK”
E n t e r N e w C o d e
. . ..
Step 2. You can key in your preferred 4-digit
number and then press “OK”
R e p e a t N e w C o d e
. . ..
Step 3. You are prompted to re-enter the same
code again and press “OK”
If the code is correct, the screen
changes to the following:
*
L a t c h . R p t . O f f
L a t c h . R p t . O n
You are requested to choose to have
all arm/disarm actions of the user to be
reported to the Central Monitoring
Station or not.
Step 4. Press “S” “T” keys to select your
option and press “OK”. The screen
returns to “General Setting” menu,
setting the Temporary code is
completed.
<
<
N
N
O
O
T
T
E
E
>
>
) There is no User Naming feature for
Temp. Code.
)
z To Delete Temp. Code
After the Temp. Code is programmed, it can be
deleted by following the steps below:
Step 1. Move the cursor to the item “Temp.
Code” then press “OK”.
Delet e
P i n - C o d e ( + O k )
Step 2. Press “OK” and the screen returns to
“Gen. Settings Menu”
z To Edit Temp. Code
After the Temp. Code is programmed, it can be
edited by following the steps below:
Step 1. Move the cursor to the item “Temp.
Code” then press “OK”.
Delet e
P i n - C o d e ( + O k )
Step 2. Press “ “ key, the next screen will
ask you to enter your new Temp. code
and repeat it for double confirmation.
Step 3. Press “OK”. The screen returns to
“General Setting” menu, editing the
Temporary code is now completed.
3. Duress Code
z Duress Code can arm/disarm the system.
When this code is used for accessing the
system, the Control Panel will report a
secret alarm message without sounding
the siren to the Call recipient to indicate of
a “Duress Situation in Progress”.
z The Duress Code consists of 4 digits and
is not activated as default by the factory.
z To Set Duress Code
Step 1. Use the arrow keys to select “Duress
Code” and press “OK”
E n t e r N e w C o d e
. . . .
Step 2. You can key in your preferred 4-digit
number and then press “OK”
Repeat N e w C ode
. . . .
Step 3. You are prompted to re-enter the same
code again and press “OK”
To Next Page
Loading...