Electrolux E30MC75JPS - Setting the Self-Clean Cycle

65
Lower Oven Self-Clean
Setting self-clean
The clean feature provides 3 different choices for
self-cleaning the lower oven. Set the clean for lite
(2 hrs), med (3 hrs) or heavy soils (4 hrs). The
example below shows setting the lower oven for
self-clean to begin immediately using a medium (3
hour) setting:
Setting delayed self-clean
You may wish to set your appliance to perform a
self-clean cycle sometime later (up to 12 hours
later). The END TIME key will determine when the
cleaning will stop.
You will need to set the END TIME out far enough
to allow for the type of clean cycle you choose
(2-3-4 hours). Remember to add 30-40 additional
minutes for the oven to cool enough and the oven
door to unlock.
The example below shows setting the lower oven
for a lite (2 hour) self-clean cycle to end at 8:00
o’clock:
After pressing start, the motorized oven door latch
willautomaticallylockthedoor.TheDOORlock
iconwillash(Fig.1).Oncethedoorhaslocked
theDOORlockiconwillremainonthroughthe
entire self-clean cycle.
After self-clean, the oven may take about 30-40
minutes to cool and unlock. A Hot message (Fig.
2) will display during this period. After cooling the
DOORlockiconwillashanddisappearindicating
that the door has unlocked.
IMPORTANT
• Aself-cleancyclewillnotstartiftheappliance
hastheCONTROLLOCKturnedon.
• Ifaself-cleancyclewasstartedbutdidnot
nishduetoapowerfailure,yourovenmay
not be completely cleaned. After power
has been restored and the oven door has
unlocked, set for another self-clean if needed.
Fig. 2
Fig. 1
Example
NOTES
• YoumaypressCANCELanytimeduringthe
cleaning process. After cancelling the self-
clean cycle, do not attempt to open the oven
dooruntiltheDOORlockiconturnsoff.
• Ifyoudesiretosetadelayedself-cleancycle
to end in 12-24 hours, set the clock mode to
24 hr.
Example
Step Press
1. Remove racks and supports
and press LOWER OVEN
2. Press CLEAN
3. Select MED or select lite
or heavy by pressing the
corresponding numeric pad.
4. Press START
Example
Step Press
1. Remove racks and
press LOWER OVEN
2. Press CLEAN
3. Select LITE
4. Press END TIME
5. Enter 800
6. Press START