25
8. Repeat installation of bolt/spacer assembly for the
other side.
9. After closing the pedestal drawer, carefully move the
washer/pedestal assembly into
position. NOTE: Because of the increased weight
caused by the addition of the pedestal, two or
more people may be required.
NOTE: The washer/pedestal assembly MUST be
on a solid floor and level for proper operation.
After leveling the washer/pedestal assembly,
adjust the lock nut on each leveling leg against
the pedestal base and tighten with a wrench.
Keep the leg extension at a minimum to prevent
excessive vibration.
10. Refer to the installation instructions that came
with the washer to properly complete electrical,
water, and drain connections. If questions arise,
please refer to the Owner’s Guide that came with the
washer for contact information.
DRYER INSTALLATION
Dryer Installation Kit
1. Remove the dryer installation hardware from the
plastic bag.
2. Attach the rear brackets to the pedestal with four
#8 screws (2 per bracket).
To Next Page
Loading...
