Electrolux GOOD - Removing the Pressure Switch; Removing the Electronic Water Level Sensor; Releasing the Console

70
2. Unplug the wire harness from the sensor.
3. Turn the sensor one quarter turn and pull out to
release it from the side panel.
4. Disconnect the hose from the sensor.
Releasing the console:
1. Disconnect the washer from the electrical supply,
remove the top panel and detergent drawer.
2. Remove the (2) screws from the rear of the top, slide
the top back and lift it off.
Removing the pressure switch: (Good
Models)
1. Disconnect the washer from the electrical supply
and remove the top panel.
2. Unplug the wires from the pressure switch.
3. Turn the pressure switch one quarter turn and pull
out to release it from the side panel.
4. Disconnect the hose from the pressure switch.
Removing the electronic water level
sensor: (Better Models)
1. Disconnect the washer from the electrical supply
and remove the top panel.