This equipment is classified as Class II (Ref. IEC 536) with respect to protection against electric shock.
WARNING
* Unplug equipment from mains supply before undertaking any maintenance tasks.
* Maintenance should only be carried out by a competent Electrician under the direction of the
Responsible body
With proper care and operation the equipment should give reliable service. Contamination, or
general misuse will however reduce the effective life of the product and may cause a hazard.
Maintenance for the equipment should include:
- Periodic electrical safety testing of the power supply unit (an annual test is
recommended as a minimum requirement).
- Regular inspection for damage with particular reference to mains leads and lug /
sockets.
Preventive maintenance for the equipment should include keeping the unit clean and protecting
it from spillage, contamination or corrosive environments.
If the equipment has been exposed to spillage or contamination, the Responsible Body is
responsible for carrying out appropriate decontamination if hazardous materials have been spilt
on or inside the equipment. Decontamination should only be undertaken under the control of
the Responsible Body with due recommended of possible hazards that may ensue. Before
using any cleaning or decontamination method, except those recommended in the Operating
Instructions, the Responsible Body should check with the manufacture that the proposed
method will not damage the equipment.
* This equipment contains insulation made from Refractory ceramic Fibres. EU Directive
EEC/67/548 classifies this material a class 2 carcinogenic, a risk if inhaled or digested.
In normal use there will be no contact with this material, but care should be taken when
servicing or disposing of the equipment. A code of Practice and Material Safety Data
Sheet are available on request, please contact your supplier.
AVERTISSEMENT.
* Coupez I‟alimention principale de I‟ appareil et laissez-le refroidir avant d‟en effectuer
I‟entretien.
* Sous la direction de I‟autorité responsible, ne confiez I‟entretien qu‟à un èlectricien competent.
* N‟UTILISEZ AUCUN SOLVANT POUR NETTOYER L‟UNE OU L‟AUTRE DES PIÈCES DE
L‟APPAREIL.
* Si I‟èquipmet est exposè à un dèversement ou à une contamination, il revient à làutoritè
responsible d‟effecture la decontamination approprièe, que le produit dangerux ait ètè renversè
à I‟intèrieur ou à I‟extèrieur de I‟appareil. A decontamination ne doit ètre enterprise que sous la
serveillance de l‟autoritè responsible et en parfaite connaissance des risques èventuels. Avant
de recourir à toute mèthode de nettoyage ou de decontamination, I‟autoritè responsible devrait
s‟assurer auprès du fabfricant que ladite mèthode ne risqué pas d‟endommager I‟appareil.
* N‟effectuez le sèchage du four qu‟après vous être assure qu‟aucune substance à faible point
d‟èclair n‟est present, compte tenu d‟une temperature de sèchage de 60 à 80ºC.
To Next Page
Loading...
