INSTALLATION INSTRUCTIONS: The equipment is Installation category (Over
Voltage category) Class II with regard to protection against electric shock (IEC
664 Sub Clause 5.6).
Environment operation conditions: indoor use only; temperatures 5°C to 40°C,
80% RH maximum; mains supply voltage fluctuations not to exceed 10%.
The equipment power supply unit must be connected to a fixed ground earthed
(grounded) mains socket outlet. If the unit is supplied without a fitted mains
plug the following connections must be made. (If in doubt consult a qualified
Electrician).
Line (Live – positive) (+)
This equipment is supplied with a universal input voltage power supply. Only
use the power supply with the equipment supplied. Only use the equipment
with the supplied power supply unit.
For additional safety it is recommended the unit be connected inline to a RCD
(Residual Current Device) or GFI (Ground fault interrupter) in the U.S.A.
Environmental Protection
It is the policy of Electrothermal to give consideration to environmental issues
in design and manufacturing without compromising end product performance
and value.
Packaging materials have been selected such that they may be assorted
for recycling. Main case Materials are moulded in ABS plastic.
At the end of your product and accessories life, it must not be discarded
as domestic waste. Ref: EU Directive 2002/96/EC on Waste Electrical and
Electronic Equipment Directive (WEEE). Please contact your distributor /
supplier for further information. For end users outside of the EU consult
applicable regulations.
The IA9200 & IA9300 products contain Nickel Metal Hydride batteries (NI MH).
Battery replacement should only be performed by the manufacture or service
agent acting on behalf of the manufacturer.
End of life battery removal should also only be performed by an authorised
recycling company. Battery removal will cause loss of memory data. Battery
removal invalidates manufacturer‟s warranty.
End of Life battery removal: Remove base and unsolder the NI MH battery from
the PCBA. Always dispose of batteries in an environmentally friendly manner
This product should only be dismantled for recycling by an authorised recycling
company.
Electrothermal is registered as Electrothermal Engineering Limited with the Environment Agency as
a producer of WEEE through an authorised compliance scheme.
To Next Page
Loading...
