(applicable only to Serial Numbers 1100 and above)
Fast Ramp Selection.
In order to facilitate the determination of unknown melt
points, a fast ramp of 10ºC/ Per min may be
selected with or without the pre-selection of a set point
temperature. This may be achieved as follows:
IA9100
Press CLEAR 3 times (or once if at set point).
Press arrowed UP key. The display will show 101.0
Press GOTO. The display will 10;10 to indicate a fast
ramp has been selected.
Press GOTO to initiate fast ramp or CLEAR to cancel
if required. The right hand L.E.D. on the GOTO key
will illuminate and the oven temperature will now rise
at 10ºC / per min to a maximum temperature of 400ºC
/ per min.
Four melt temperatures may be stored and recalled in
the normal manner.
Press CLEAR twice.
Press in turn ENTER;1;0;0; to enter 10.0
The display will show 010.0
Press GOTO. The display will show 10:10 to indicate
that a fast has been selected.
Press GOTO to indicate a fast ramp or CLEAR to
cancel if required.
The right hand L.E.D. on the GOTO key will be
illuminated and the oven temperature will now rise at
10ºC/ per min to a maximum temperature of 400ºC
Four melt temperatures may be stored and recalled in
the normal manner.
To Next Page
Loading...
