35
English
• If the shredding chamber gets clogged up, switch off the machine to remove the blockage.
Make sure to wait for the blades to come to a complete standstill, before carrying out any
operation on the machine. For safety’s sake, disconnect the spark plug wire.
• Stop the feed roller by pushing the safety-stop-bracket.
• Press the Action button to switch off the blade axle.
• Move the throttle control lever to the minimum position.
• Stop the engine using the ignition key.
• Open the maintenance hatch in order to access the blade axle and the discharge
system(Axelero
TM
) (“11.2.4 Opening the AxeleroTM chamber” on page 42)
• Check the Axelero
TM
impeller for damage.
• Open the sieve in order to access the chippings chamber. (“11.2.5 Opening the shredding
chamber” on page 43)
• Check the blades and the blade holders for damage.
• In the event of damage, carry out repairs before shredding again.
• If you notice a foreign object in the garden waste in the loading hopper, perform the following
steps:
• Push the OUT button to stop the feed roller.
• Press the OUT button again in order to eject the cut waste.
• Press the Action button to switch off the blade drive.
• Stop the engine
• Now the feed hopper can be reached safely in order to remove the foreign objects
among the cut waste.
• Remove any foreign objects.
• If you notice a strange noise during the work, immediately stop shredding. Stop the engine and
investigate the cause of the defect. Before proceeding, perform the necessary repairs.
To Next Page
Loading...
