Eliet Super Prof - Transporting the Machine

38
English
10. Transporting the machine
• Allow the shredder chamber to completely empty. The shredding chamber and the Axelero
TM
must be empty before transporting the machine. The feed opening should not contain any
branches.
• Before loading the Super Prof onto a trailer or into a van,
the blow chute must be collapsed so that it leans on the
chassis support points. This is the transport position for
the blow chute. For the instructions for collapsing the
blow chute see “11.2.6 Putting the blow chute in working
or transport position” on page 46
• Use slip resistant ramps to load the machine into a van or a trailer. Make sure that they are
securely attached to the vehicle or trailer.
• The maximum allowable lateral slope angle amounts to 10%.
• Under no circumstances must the angle of the up and/or down ramp be greater than 20%.
• Be careful and composed when loading and unloading the shredder so that the machine does
not tip over and give rise to an accident.
• When coming down the ramp, move down backwards facing the machine.
• If gravity causes the machine to descend more quickly down the slope than is desired, quickly
move the control handle to the other drive direction. This enables you to hydraulically brake
the machine.