30
English
9.6.2 Turning and positioning the blowchute and deflector-flap
To position the blow chute, the lever (1) is released and the handle
(2) on the chute is used to turn it to the appropriate position.
Once the blow chute is in the appropriate position, the lever (1)
can be secured again.
In order to put the
deflector flaps in the
desired position, the
lever (3) is released, the
handle (4) is used to
position the deflector
flap and the lever (3) is
then replaced in order to
secure the deflector flap.
9.6.3 During the work
• Be careful when performing work. While operating the machine, focus your concentration
completely on the work
• Start the engine(“9.4 Starting the Petrol Engine” on page 25).
• Allow the machine to run idle for about 5 minutes.
9.6.3.1 Starting the blade system and discharge system
• Always shred at full throttle
• Set the thrust lever to maximum or push the PUSH button on the machine to run at full gas.
In order to shred, the blades and the discharge system must be
started. The coupling must be engaged in order to do so. On the
dashboard, there is an illuminated button with the word ‘Action’.
Push this Action button in order to begin shredding.
To Next Page
Loading...
