Eliet Super Prof - Changing the Engine Fuel Filter (Oil Filter); Changing the Hydraulic Oil

50
English
11.3.6 Changing the engine fuel filter (Oil filter)
• Switch off the engine and remove the ignition key from the ignition switch.
Warning:
Let de motor cool down completely, in order to avoid fire.
• Release the tensioning belts (2) using a flat-head screwdriver.
• Pull the filter out from between the fuel lines.
• Insert the new filter (whilst taking note of the direction of the
arrow marked on the filter). New filters are available from
your local Eliet dealer or from a B&S service center.
• Move the tensioning belts on the section of fuel hose that sits
on the filter.
• Retighten the straps.
• Clean up any spilt fuel.
• Start the engine and inspect for signs of leakage.
11.3.7 Changing the hydraulic oil
• Place a collecting tray (15l capacity) under the oil outlet. (1).
• Open the filler cap (2).
• Open the drainage bung (1) (socket 6mm) and let the oil run
into the tray.
• Replace the drainage bung.
• Fill the motor with 12l of new oil (read “16.1 Technical specifica-
tions of the lubricants and fuel” on page 77) and shut the
filler cap.
• Clean up any spilt fuel.