43
English
Warning:
when switching off the petrol engine or disengaging the coupling, it may take up
to 7 seconds before the Axelero
TM
comes to a complete standstill.
Caution:
Before opening the Axelero
TM
chamber, the blow chute should be put into its
working position. The Axelero chamber cannot be opened if the blow chute is in
transportmode. Read how to put the blow chute into the working position. (Read
“11.2.6 Putting the blow chute in working or transport position” on page 46)
• Push the two locking levers (1) towards one another and
hold them together with one hand.
• With your other hand, pull the handle (2) and tilt the
maintenance hatch upwards
.
• Secure the maintenance hatch using the lock (3);
this will prevent the hatch unexpectedly shutting
during maintenance and causing injury.
• In order to shut the maintenance hatch, the lock must be undone while the handle is held.
The hatch is then lowered and pushed against the stopper so that the locking pins secure it in
place. Pull the handle once again to make sure that the maintenance hatch is closed properly.
11.2.5 Opening the shredding chamber
Caution:
Make sure the blades have come to a standstill before opening the shredding
chamber. Turn the motor off and take the key out of the ignition.
To Next Page
Loading...
