Eliet Super Prof - Changing the Hydraulic Oil Filter (Hydraul. Filter)

2 cm
51
English
11.3.8 Changing the hydraulic oil filter (Hydraul. filter)
• Organise the replacement of the filter cartridge when the hydraulic oil is being changed.
• Provide a collecting tray with a 15l capacity and place it under the filter.
• Remove the used filter (1) after allowing the oil to drain (if
stubborn, use an oil filter wrench).
• Apply a film of new oil to the sealing gasket of the new
filter.
• Screw the new filter onto the mounting base until the
gasket just touches.
• Now tension it fully by turning it a further half to three-
quarters of a turn.
• Fill the hydraulic tank via the filler opening (2) up to 2 cm
under the neck of the filler cap.