Eliet Super Prof - Page 7

7
English
11.2.4 Opening the AxeleroTM chamber . ........................................... 42
11.2.5 Opening the shredding chamber . ........................................... 43
11.2.6 Putting the blow chute in working or transport position . ....................... 46
11.3 Engine maintenance . .......................................................... 47
11.3.1 Checking the oil level in the engine crankcase + refilling . ....................... 47
11.3.2 Engine oil change (Engine Oil) . .............................................48
11.3.3 Changing the oil filter (Oil filter) . ............................................ 48
11.3.4 Cleaning the air filter (Clean air filter) . ....................................... 49
11.3.5 Changing the air filter . .................................................... 49
11.3.6 Changing the engine fuel filter (Oil filter) . ....................................50
11.3.7 Changing the hydraulic oil . ................................................. 50
11.3.8 Changing the hydraulic oil filter (Hydraul. filter) . ...............................51
11.4 Machine maintenance . ........................................................ 52
11.4.1 Checking the blades . ....................................................... 52
11.4.2 Sharpening the blades . .....................................................53
11.4.3 Reversing and renewing the shredding knives (Turn Knives) . ................... 55
11.4.4 Checking the drive belt for correct tension (Chk Belt Tens.) . .................... 60
11.4.5 Tightening the V-belt (Tighten belt) . .........................................61
11.4.6 Changing the belts (Replace Belts) . ......................................... 62
11.4.7 Checking the tension of the drive chain for the feed roller . ..................... 63
11.4.8 Checking and adjusting the tracks for correct tension (Cross Country model) . .... 63
11.4.9 General lubrication (Lubrication) . ...........................................64
11.5 Maintenance schedule . ........................................................ 68
11.5.1 Special maintenance . ...................................................... 69
11.5.2 Daily maintenance . .........................................................70
11.5.3 Maintenance after 5 hours . .................................................70
11.5.4 Maintenance after 10 hours . .................................................70
11.5.5 Maintenance after 25 hours . ................................................71
11.5.6 Maintenance after 50 hours . ................................................71
11.5.7 Maintenance after 100 hours (or six-monthly) . .................................71
111.5.8 Maintenance after 200 hours (or annually) . ..................................72
12. Winterizing the machine . .................................................73
13. Options . ...............................................................74
13.1 Sieve screening . ...............................................................74
14. Equipment specifications . ................................................75
15. EC Declaration of Conformity . .............................................76
16. Appendix . ..............................................................77
16.1 Technical specifications of the lubricants and fuel . .................................77
16.2 List of torques . ................................................................78
16.3 Troubleshooting - resolving problems . ...........................................79
16.3.1 F00: Oil Press. Low . ........................................................79
16.3.2 F01: Safety Cover . .........................................................79
16.3.3 F02: Oil Pr. sensor . ........................................................79
16.3.4 F03: Short Clutch . ........................................................ 80
16.3.5 F04: Wiring Clutch . .......................................................80