48
Pull the thread up and through the right retractable
thread guide q from behind.
Pull the thread under and around the bobbin winding
tension disc w.
Pass the thread through the hole in the bobbin e
from inside to the outside. Place the bobbin on the
bobbin winder spindle r.
Push bobbin winder stop t to the left.
Holding the free end of the thread, press the
“Bobbin Winding” key y. (A separate motor winds
the bobbin, allowing you to sew at the same time
bobbin winding occurs.)
Press the “Bobbin Winding” key to STOP bobbin
winding after the bobbin has made a few turns. Cut
the thread tail close to the hole in the bobbin.
Press the “Bobbin Winding” key again. When the
bobbin is fully wound, bobbin winding is stopped
and bobbin winder stop will automatically move
right. If you do not wind a full bobbin, stop bobbin
winding and return bobbin winder stop to the right.
Cut thread.
q
w
e
r
t
y
To Next Page
Loading...
