50
Inserting the Bobbin
Place the bobbin in the bobbin case with the
thread running counterclockwise.
q
Guide the thread into notch q on the front side of
the bobbin case.
Hold the bobbin with your right hand and pull the
thread to the left, through the tension spring
blades w.
Continue pulling the thread lightly until the thread
slips into notch e.
Pull out about 15 cm (6˝) of thread.
Replace the bobbin cover plate.
Refer to the chart shown on the bobbin cover
plate to check the threading.
w
e
To Next Page
Loading...
