24 Display Operation Manual BC2000 and JC2000 Controller ~ Doc. No. 2055882, Issue 5.1, June 2014
Change Temperature Units
By default controller temperature readings are in Celsius. To change temperature
units to Fahrenheit, use the “Temp. Unit” parameter under “System.”
Main Menu ► System ► Temp. Unit
Run Relay Test
This test allows the user to check that the alarm cable has been connected to the
user’s alarm transport equipment properly. See the section “Alarm Cable
Connection” on page 8 for information on the output alarm relays.
Once test mode is enabled each relay can be set to either an active or inactive
alarm state. The relay changes state when activated. To access the relay test
enable feature:
Main Menu ► Activate ► Relays ► Test Mode
To select individual relay states:
Main Menu ► Activate ► Relay X
NOTE: It is recommended to set all relays to inactive once the test is complete.
Change Audible Alarm
The audible alarm can be set for any alarm status (major, minor, or major and minor
or any alarm).
Main Menu ► Alarming ► Audible ► Edit
Change Beep Volume
The beep volume can be adjusted on a scale of 0% to 100% as follows:
Main Menu ► Display ► Beep Volume ► Edit
To Next Page
Loading...
Need help?
General
