Need help?Do you have a question about the Eltek Smartpack2 and is the answer not in the manual?
General| Type | Power System Controller |
|---|---|
| Input Frequency | 45 - 65 Hz |
| Operating Temperature | -40°C to +70°C |
| Communication Ports | RS232, Ethernet |
| Protocols | Modbus, SNMP |
| Protection Features | Overvoltage, Overcurrent, Over Temperature |
Details crucial safety measures for handling and using the DC power supply system.
Outlines environmental considerations and protection guidelines for the DC power system.
Specifies essential safety requirements for the installation of the DC power system.
Explains the necessity and method of CAN bus termination for optimal communication.
Details the process of upgrading controller firmware using an SD card.
Explains how to upgrade controller firmware using a PC and the Eltek Network Utility.
Explains how to configure alarm monitors and their parameters.
Categorizes alarm monitors based on the type of input signal they process.
Lists and describes common configuration parameters for various alarm monitors.
To Next Page
