3 About Power System Configuration
22 User's Guide Smartpack2 Master Controller 350020.013, Issue 2.0, 2014 Jan
When upgrading the firmware of controllers and control units — if several units of the
same type are connected to the CAN bus — the Smartpack2 Master controller will request
you to specify the CAN bus ID number of the unit to upgrade.
Flash Memory Storage
You can store files in the Smartpack S controller’s embedded Flash Memory (data storage
device) and use them for firmware upgrading of controllers and control units, as well as for
storage of logs, language codes, and for exporting & importing configuration files.
When upgrading the firmware of controllers and control units — if several units of the
same type are connected to the CAN bus — the Smartpack S controller will request you to
specify the CAN bus ID number of the unit to upgrade.
FTP Client
The files stored in the controller’s Flash memory are also accessible from a computer, via
the FTP client embedded in the controller’s web-based user interface.
NOTICE:
You must use the “Admin” log in account, to be able to use the embedded FTP client.
An external FTP client, such as e.g. “FileZilla” (freeware) — running on a computer
connected to the controller’s Ethernet port — can also be used to access the files on the
controller’s embedded Flash memory
WARNING:
It is not recommended to use the FTP client embedded in Windows Explorer.
WARNING:
Before uploading files to the Flash memory (4MB), check that there is enough storage space. Also, consider deleting files
that are no longer necessary.
To Next Page
Loading...
Need help?
General
