Eltek Smartpack2 - Statistics Options

3 About Power System Configuration
User's Guide Smartpack2 Master Controller 350020.013, Issue 2.0, 2014 Jan 19
Battery Test Log
The Battery Test Log is displayed in a results table; each row of data represents a battery
test. Also, the battery quality, calculated by completed battery tests, and other test
parameters are displayed.
Example of Battery Test Log table displayed in Smartpack S controller’s submenu:
Logs/Report > Battery Test Log
#
StartTime
Durat.
Typ
Descr
Amp
Q%
EndV
Note
09:58
34
Manual
-----------------
-68
70%
45.49
----------------
----
Using the CWUI (Controller Web-based User Interface) or PowerSuite you can also
display the test results for a battery test in a line graph.
Inventory Report
The Inventory Report presents information that describes the power system, the site’s
name , serial number, installation and service dates, software name, etc.
Example of Inventory Report table in Smartpack S controller’s submenu:
Logs/Report > Inventory Report
#
Description
Note
Company
Site
Model
Install Date
Serial N
Service Date
Responsible
Message 1
Message 2
(Installed HW and SW info, part #, serial #, version #, etc.)
6 - Statistics options
This logical group collects and presents relevant system data and calculated statistics, such
as average results, peak values, etc.
Example of the Statistics table available in Smartpack S controller’s submenu:
Statistics
#
Description
Reset
Average
Peak
Note
BatteryVoltage
 No
52,48
52,61
BatteryCurrent
 No
-35
0
Battery Temp
 No
41
0
Load Current
 No
35
50
Rectifier Current
 No
75
120
Mains Volt 1
 No
225
235