Eltek Smartpack2 User Manual

3 About Power System Configuration
User's Guide Smartpack2 Master Controller 350020.013, Issue 2.0, 2014 Jan 17
4 - Commands options
The options in this logical group let you issue or activate specific commands, such as
resetting manual alarms, deleting the event log, starting battery tests, etc.
Issuing commands is allowed at this level, using a Pin-Code.
NOTICE:
The default Service Access Level password or Pin-Code is
<0003>, which may be changed for security reasons.
The commands are organized in following groups:
 System Commands
 Battery Commands
 Outputs Test
Read about “Output Test Commands” on page 31

Eltek Smartpack2 Specifications

General

Type	Power System Controller
Input Frequency	45 - 65 Hz
Operating Temperature	-40°C to +70°C
Communication Ports	RS232, Ethernet
Protocols	Modbus, SNMP
Protection Features	Overvoltage, Overcurrent, Over Temperature