Display Operation Manual BC2000 and JC2000 Controller ~ Doc. No. 2055882, Issue 5.1, June 2014 17
Figure 11 - Page 3: Profile and Prest
To change the preset, see the section “Restore Preset” on page 23.
Temperature Probes (If Installed)
If temperature probes are installed, the temperature readings for the probes appear
on a home screen page that appears between the system status page and the date
and time page.
Figure 12 - Temperature Probe Page (if probes are installed)
Screen Saver
The screen saver serves two purposes:
• Log out of administrative access if the interface is idle for too long
• Prevent screen burn-in from excessive exposure of a single screen image
The timeout period that triggers the screen saver is configurable. Once the timeout
period expires, the system automatically logs out and goes into screen saver mode.
The screen saver shows system voltage and current.
1A01-10VV
Preset A
54.00V 100A
Menu
Profile
Page 3
Profile Number (“A01”)
Preset (A, B, or C)
Probe 3 17C
Probe 4 59C
54.00V 100A
Menu
Temperature
Reading
Temperature
Probe Number
To Next Page
Loading...
Need help?
General
