ELTEX MES1000 User Manual

122 MES1000, MES2000 Ethernet Switches
ip_address
no ip igmp snooping vlan
vlan_id querier address
Restore the default value. By default, if the IP address is
configured for VLAN, it will be used as IGMP Snooping Querier
source address.
ip igmp snooping vlan
vlan_id immediate-leave
vlan_id: (1..4094)/disable
Enable IGMP Snooping Immediate-Leave process for the
current VLAN. The port will be immediately deleted from the
IGMP group after IGMP leave message is received.
When adding host-based option, fast-leave mechanism will
respond only when all users connected to this port
unsubscribe from the group (user counter is based on src-MAC
addresses in IGMP-report headers).
no ip igmp snooping vlan
vlan_id immediate-leave
[host-based]
Disable IGMP Snooping Immediate-Leave process for the
current VLAN.
ip igmp snooping vlan
vlan_id immediate-leave
host-based
vlan_id: (1..4094)/disable
Enable IGMP Snooping Immediate-Leave process for the
current VLAN. The port will be immediately deleted from the
IGMP group after IGMP leave message is received, if there are
no more clients that require this group.
no ip igmp snooping vlan
vlan_id immediate-leave
Disable IGMP Snooping Immediate-Leave process for the
current VLAN.
VLAN interface configuration mode commands
Command line request in VLAN configuration mode appears as follows:
console(config-if)#
Table 5.121 —VLAN interface configuration mode commands
Command
Value/Default value
Action
ip igmp robustness count
(1-7)/2
Define IGMP robustness value.
If the data loss is discovered for the channel, robustness value
should be increased.
no ip igmp robustness
Restore the default value.
ip igmp query-interval
seconds
(30–18000)/125 seconds
Define the timeout, upon the expiration of which, the system
will send basic queries to check the activity of multicast group
participants.
no ip igmp query-interval
Restore the default value.
ip igmp query-max-
response-time seconds
(5-20)/10 seconds
Set the maximum query response time.
no ip igmp query-max-
response-time
Restore the default value.
ip igmp last-member-
query-count count
(1-7)/robustness variable
value
Define the quantity of queries sent before the switch will
determine the absence of multicast participants.
no ip igmp last-member-
query-count
Restore the default value.
ip igmp last-member-
query-interval milliseconds
(100-25500)/1000 ms
Define the query interval for the last participant.
no ip igmp last-member-
query-interval
Restore the default value.
Ethernet interface configuration mode commands (interface range)
Command line request in interface configuration mode appears as follows:
console(config-if)#
Table 5.122 —Ethernet interface configuration mode commands
Command
Value/Default value
Action
switchport access
multicast-tv vlan vlan_id
vlan_id: (1-4094)
Enable forwarding of IGMP queries from client VLAN to
Multicast VLAN and multicast traffic to client VLAN for the
interface in 'access' mode.
no switchport access
Disable forwarding of IGMP queries from client VLAN to

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English