60 MES1000, MES2000 Ethernet Switches
sntp server {ipv4_address |
ipv6_address |
{ ipv6-link-local-address }
%{vlan {integer} | ch {integer}
| isatap {integer} |
{physical-port-name}}|
hostname}
[poll]
[key keyid]
hostname: (1..158)
characters
keyid: (1..4294967295)
Define SNTP server address.
- ipv4_address—Ipv4 address of the network node.
- ipv6_address—Ipv6 address of the network node.
- ipv6z_address—Ipv6z address of the network node for ping.
Address format {ipv6-link-local-address}%{interface-name}
ipv6-link-local-address—local link IPv6 address
interface-name—name of the source interface is specified
in the following format:
vlan {integer} | ch {integer} | isatap {integer} | {physical-
port-name}
- hostname—domain name of the network node
- poll—enable polling
- keyid—key identifier
no sntp server {ipv4_address
| ipv6_address |
{ ipv6-link-local-address}%
{vlan {integer} | ch {integer} |
isatap {integer} |
{physical-port-name} }|
hostname}
Delete the server from NTP server list.
port-number:
(1..65535)/123
Define UDP port of SNTP server.
Restore the default value.
Allow to get the timezone and daylight saving data from DHCP
server.
Deny to get the timezone and daylight saving data from DHCP
server.
Interface configuration mode commands
Command line request in interface configuration mode appears as follows:
console(config-if)#
Table 5.31 —List of system time configuration commands in the interface configuration mode
Allow the operation of SNTP clients, that support packet
transmission to the nearest device in a group of receivers, and
to broadcast SNTP client for the selected interface (ethernet,
port-channel, VLAN).
Restore the default value.
Example execution of commands
Show the system time, date and timezone data:
console# show clock detail
15:29:08 NSK(UTC+7) Jun 17 2009
Time source is SNTP
Time zone:
Acronym is NOV
Offset is UTC+7
Summertime:
Acronym is NSK
Recurring every year.
Begins at first Sunday of April at 2:00.