ELTEX MES1000 User Manual

MES1000, MES2000 Ethernet Switches 95
Table 5.81 —Ethernet interface configuration mode commands, port group
Command
Value/Default value
Action
spanning-tree disable
-/enabled
Disable STP protocol operation for the configured interface.
no spanning-tree disable
Enable STP protocol operation for the configured interface.
spanning-tree cost cost
(1..200000000)/ see Table
5.82
Set path value via the following interface.
no spanning-tree cost
Set the value based on the port transfer rate and the method
of route value definition, table 5.82.
spanning-tree port-priority
priority
(0..240)/128
Set the interface priority in the STP spanning tree.
Priority value must be divisible by 16.
no spanning-tree port-
priority
Restore the default value.
spanning-tree portfast
[auto]
-
Enable mode, where port immediately switches to
transmission mode when the link is established without
waiting for the timer expiration.
- auto—add 3 second delay before entering the transmission
mode.
no spanning-tree portfast
Enable momentary transition into transmission mode when
the link is established.
spanning-tree guard root
-/protection disabled
Enable root protection for all STP spanning trees for the
selected port. Such protection denies the interface to be the
root port of the switch.
no spanning-tree guard
root
Restore the default value.
spanning-tree bpduguard
-/protection disabled
Enable protection, that disables the interface, when BPDU
packet is received.
no spanning-tree
bpduguard
Disable protection, that disables the interface, when BPDU
packet is received.
spanning-tree link-type
{point-to-point | shared}
Default value for full-
duplex port—'point-to-
point', for half-duplex—
split'.
Define the transfer state for RSTP protocol and specify the
connection type for the selected port—'point-to-point' or
'split'.
no spanning-tree link-type
Restore the default value.
spanning-tree bpdu
{filtering | flooding}
-
Define BPDU packet processing mode by the interface with
disabled STP protocol.
- filtering—packets are filtered for the interface with STP
BDPU protocol disabled
- flooding—untagged BDPU packets are transmitted for the
interface with STP protocol disabled, tagged packets are
filtered
no spanning-tree bpdu
Restore the default value.
spanning-tree binding-
process id
(1..31)/0
Tethers the port to the specific process. By default, all ports
are controlled by the zero process.
no spanning-tree
binding-process
Restore the default port tethering.
Table 5.82 —Route value set by default (spanning-tree cost)
Interface
Method for defining the path value.
Long
Short
Port-channel
20000
4
Gigabit Ethernet (1000 Mbps)
20000
4
Fast Ethernet (100 Mbps)
200000
19
Process configuration mode commands
Command line request in tree configuration mode appears as follows:
console(config-mstp-process)#

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English