EMBRON Hatteland E Series - Reading Internal Temperature; Using the Emmc as a Backup;Recovery Device When SSD Is Used; Install Operating System (OS)

105
Additional features overview/details
Appendix
IND100077-219
Reading internal temperature
SCOM* command “TMP” can be used to read out internal temperature sensor value.
*If you are not familiar with the SCOM protocol, please review the Hatteland Technology’s Serial Remote Control
Interface (SCOM) protocol document can be downloaded from:
https://www.hattelandtechnology.com/hubfs/pdfget/inb100018-7.htm
Using the eMMC as a backup/recovery device when SSD is used
Solution is pending implementation.
- Available for Microsoft® Windows® 10 only.
- eMMC will be used as boot and recovery device.
- The feature requires an SSD for the Operating System.
The backup is congurable, and can take periodic snapshots of a running system, and restore the unit to this state or
factory settings. It will be possible to replace the SSD and restore the unit to the last backup with ease.
In the event of a drive failure or replaced SSD, the system will boot to recovery mode, where the system can be
restored.
Install Operating System (OS)
For units without factory installed OS:
To install any OS on the unit, follow the instructions given by the manufacturer.