How this document is organized
EMC VNX7500 Parts Location Guide 3
How this document is organized
The major sections of this guide are listed in the following table.
Related documentation
EMC provides the ability to create step-by-step planning, installation, and maintenance
instructions tailored to your environment. To create VNX customized documentation, go
to: https://mydocs.emc.com/VNX/.
To download a PDF copy of the desired publication, go to the following sections:
◆ For hardware-related books, go to the About VNX section, and then select Learn about
VNX. Next, follow the steps in the wizard.
◆ For technical specifications, go to the About VNX section, and then select View
technical specifications. Next, follow the steps in the wizard.
◆ For installation, adding, or replacing tasks, go to the VNX tasks section, and then
select the appropriate heading. For example, to download a PDF copy of the
VNX7500
Block Installation Guide
, go to Install VNX and follow the steps in the wizard.
◆ For server-related tasks, go to the Server tasks for the VNX5300, VNX5500, VNX5700,
and VNX7500 section, and then select the appropriate heading. For example, to
download a PDF copy of Adding or replacing hardware, go to Add or replace hardware
and follow the steps in the wizard.
Title Description
“VNX7500 Block and File
platform stackup” on page 4
Describes and shows the front and rear views of a typical
VNX7500.
“VNX7500 components” on
page 9
Provides a description of the components that comprise a
VNX7500. Along with a description, illustrations of each
component are also shown.
“Standby power supplies
(SPSs)” on page 9
Describes and illustrates the part number label locations of the
SPS.
“Storage processor enclosure
(SPE)” on page 11
Describes and illustrates the part number label locations of an
SPE and the components that comprise the SPE.
“Data Mover enclosure” on
page 18
Describes and illustrates the part number label locations of the
DME and the management module.
“I/O modules” on page 23 Describes and illustrates the part number label locations of the
I/O modules that comprise the SPE and the DME.
“Small form-factor pluggable
(SFP)” on page 36
Describes and illustrates the part number label locations of the
SFP transceiver modules used in the DME.
“DIMMs” on page 39 Describes and illustrates the part number label locations of the
memory module or dual-inline memory modules (DIMMs) used
in the DPE and the DME.
“Disk-array enclosure (DAE)” on
page 43
Describes and illustrates the part number label locations of the
three types of DAEs available for the VNX7500.
To Next Page
Loading...
Need help?
General
