CHAPTER 8
Setup
After you have completed all of the installation steps, continue to set up your system by
performing these post-installation tasks:
l
Connect a management station............................................................................. 48
l
Initialize your storage system................................................................................ 48
l
Update the storage system software and register your system............................... 49
l
Check system events.............................................................................................50
l
Install ESRS and configure ConnectHome.............................................................. 51
l
Configure servers for VNX systems.........................................................................51
l
Provision storage.................................................................................................. 51
l
Attach bezels........................................................................................................ 52
Setup
47
To Next Page
Loading...
Need help?
General
