3. If an updated version is available, then run the Install Software wizard to install the
update.
Running the storage system registration wizard
The USM Storage System Registration Wizard will collect system information and send it
to your service provider using a secure channel.
For all VNX systems running version 7.1 or later, or for any version of a VNX for Block
system, complete the following steps to register your system:
Procedure
1. Start the Unisphere Service Manager (USM) by doing either one of the following:
l
Click the Unisphere Service Manager icon on your desktop, or
l
Select Start > All Programs or Start > Programs, then select EMC > Unisphere >
Unisphere Service Manager > Unisphere Service Manager; or mouse over to the
left bottom corner of the taskbar and click Start, then right-click Desktop > All Apps
> EMC > Unisphere > Unisphere Service Manager > Unisphere Service Manager.
2. Log into the system to be registered.
You must log into the system to be registered before proceeding; otherwise, the
system will not appear in the list of systems.
3. Select the system to register from the list of systems.
4. Select Registration > Register storage system. This will launch the Storage System
Registration Wizard, which will walk you through the necessary steps.
Check system health
You can run a quick and real-time check on the connectivity, management, and storage
component status of your VNX system.
The health check checks network connectivity, management service status, Storage
Processor status, Hot Spare status, disk faults, disk status, whether VNX OE for Block has
been committed, and hardware component faults.
You can also use USM to:
l
Install and update Firmware
l
Install language packs (if purchased)
l
Install software enablers (if purchased)
Checking system health
To check the system health:
Procedure
1. From within the USM, go to the System tab of the Tools section.
2. Select Health Check.
3. Log out of USM and close it.
Check system events
Log in to Unisphere to confirm the health of your system and to check system alerts,
event logs, and statistics.
Setup
50 EMC VNX Series VNX5400 Block Installation Guide
To Next Page
Loading...
Need help?
General
