Emerson 1410 - Page 46

38
Reference Manual
00809-0200-4410, Rev BC
Host Integration
July 2017
Host Integration
To add a new data point to the EtherNet/IP register map:
1. Select New entry.
2. Complete all of the table entries for the new data point (note that the entry columns may vary based
on the EtherNet/IP communications settings).
3. Repeat for each new data point.
4. Select Submit.
5. When changes have been accepted, select Return to form.
See Table 5-1 on page 33 for options of parameters that can be mapped.
Table 5-4. Summary of Terms Used for EtherNet/IP Mapping Page
Terms Description
Input Instance EtherNet/IP Input Static Assembly Instance - 496 bytes
Output Instance EtherNet/IP Output Static Assembly Instance - 496 bytes
Member EtherNet/IP Instance Member in which data will get produced or consumed
Point Name Assigned data point in the format HARTtag.parameter
New entry Creates a new entry in this table
<<First Navigates to the first page of this table
<<Previous Navigates to the previous page of this table
Search Finds the next occurrence of the characters entered into this field
Next>> Navigates to the next page of this table
Last>> Navigates to the last page of this table
Delete Selected Removes the selected entry from this table
Select All Selects all table entries
Select None Deselects all table entries
Select Errors Selects all table entries that have an error message
Submit Accepts all changes (highlighted in yellow)