Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
February 2022
9
Resticted Menu Routines
Section 3: Restricted Menu Routines
3.14 Bus Protocol
This parameter allows the user to select the communication protocol between the base card and
fieldbus interface card. I20 and I24 are the two available options. Refer to the relevant XTE3000 bus
protocol manual to correctly set this parameter.
3.15 PID
This function is not implemented. It is normally set to DISABLED.
3.16 Reserved Routines
3.16.1 SW Type
This routine must be set to "XTE."
3.16.2 Term Board
This routine must be set to "I24_V4."
3.16.3 Additional Var.
The standard value is "MASK" and the following data can be viewed:
• Output torque
• Motor speed
• Main voltage
• Current
• Temperature
• Time
• Date
• Alarm
• Warning
• Ktemp
• Mot temp
• Term temp
• Log status
• Wireless report
• Node report*
• FDI report*
• Base report
• Term report
• Ain/Aout report*
• EFS report*
The data with * are present only if the relevant modules are present.
To Next Page
Loading...
Need help?
General
