Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
February 2022
3
Reserved Passwords
Section 2: Reserved Passwords
Upon having changed any parameter in the RESTRICTED menu, actuator power must be cycled in
order for the changes to take effect.
Contact Emerson Lifecycle Services to request access to the Level 1 and Level 2 passwords.
The list below shows the available routines in the ACTUATOR SETUP menu:
• Stroke limits
• Torque setup
• PST setup*
• ESD setup*
• EFS/PST*
• Remote controls
• Local controls
• Output relays
• Positioner*
• Fail-safe*
• Out 4 - 20 mA*
• Interlock*
• 2 speed timer
• Bus*
• Miscellaneous
• Restricted
• Reserved
The routines with marked with an asterisk (*) are present only if the relevant electronic cards are
present. Should the bus interface be LonWorks, then the BUS routine will display as "FDI CONTROL."
The RESTRICTED menu routine will only appear if the Level 2 password is entered.
To Next Page
Loading...
