Section 5 - Wiring Techniques Page 5-5 S1400T-2808B
line as close to the modem as possible. Any unit equipped with a radio or modem must be
connected to a known good earth ground via the units Ground Lug.
5.2.10 Secure Wiring Connections
Make sure that all wiring connections are secure. In time wires that were once round will
become flattened due to the pressure applied by screw compression type terminals and site
vibrations. After a while these compression screws have a tendency to become loose. Part of
a good maintenance routine should be to check and tighten all screws associated with
wiring terminal connections. Avoid nicking the wire(s) when stripping insulation.
Remember, nicked conductors will lead to future problems. Also remember to provide some
cabling slack and strain relief.
If installing stranded or braided wiring that has not been tinned, be sure to tightly twist
the end (in the same direction as manufactured) and then trim off any frizzed wires.
To Next Page
Loading...
