Max/Min readings (MAXIMUM, MINIMUM)Figure 7-1:
7.5 Reset the total (rESEt TOTAL?)
If manual Total Reset is enabled in the Program menu, the total may be reset by pressing
the Reset button and using the Enter button to confirm the reset.
Additionally if programmed for manual reset, the total may be reset using a normally open
pushbutton connected across the terminals RST and COM.
Note
The total is cleared immediately when Enter button is pressed. Totalization will then continue, even if
the Enter button or external reset button continues to be held down/triggered.
7.6
Reset the grand total (rESEt Gr TOT?)
If manual Grand Total Reset is enabled in the Program menu, the grand total may be reset
using the Reset button.
To reset the grand total, display the grand total by pressing the Up/Display button. While
grand total is being displayed, press the Reset button. Confirm the reset with the Enter
button.
7.7
Reset Max/Min readings (RESET MAXIMUM,
MINIMUM)
The maximum and minimum readings may be reset by pressing the Reset button while
displaying either the maximum or minimum. The display will show RESET to verify the
reset of maximum or minimum value.
Startup procedure
90 LTM Internal Display
To Next Page
Loading...
